19.9.10

Electronics Trivia 9

OP AMP comparator circuits uses:

  • no feedback

In any 3 ½ digit voltmeter, the largest   number that can be read is:

  • 0999

PIV is applied across a diode when it is:

  • reversed biased

Heaviside-Campbell equal ratio bridge is used to measure:

  • self-inductance in terms of mutual  inductance

Primary cause of linear distortion in an amplifier:

  • reactance associated in the circuit and the active amplifying element.

Reverse current in a silicon junction nearly doubles every ____ rise in temperature.

  • 6 degrees

The voltage wave is applied across a pure capacitor, as compared to a fundamental voltage, the reactance offered by the capacitor to the third harmonic voltage is:

  • one-third

The ratio of energy stored and returned either capacitor or inductor, to the dissipated energy by the device resistance:

  • quality factor

Process of adjustment of a scale to agree  with the accepted/ certified constant:

  • calibration

Any solid object has a maximum of ___ degrees of freedom:

  • 6

An IC which is made up of spurting material in a ceramic substrate is called:

  • thin film IC

A scale of an indicating instrument whose each division represents the same value is also known as:

  • linear scale

An SCR semiconductor is made up of

  • 2 P types and 1 N type

Hays bridge is particularly used to measure:

  • inductive impedances with large phase angle

Devices used to reduce amplitude of a signal waveform:

  • attenuator

A proper biased NPN transistor, the electron in the emitter:

  • passes through base to collector

The main reason why electrons tunnel through PN junction is that:

  • the depletion region is extremely thin

The efficiency of a class A amplifier can be increased by using:

  • transformer coupled load

Produces the highest torque in DC motors:

  • Series

Works best at high frequencies:

  • Ceramic

Each impedance R+jXL

  • correspond to a unique point in the RL  plane
  • correspond to a unique inductance reactance
  • correspond to a unique resistance

Ability of an instrument retains its performance throughout its specified operating life and storage life:

  • Stability

Volume of an atom divided by the cell volume:

  • Packing Factor 

By which method protection against direct lightning strokes and high voltages sweep wave is provided:

  • lightning arrester and ground wires

The induced emf in the armature conductor in a dc motor is:

  • sinusoidal

Major difference between the construction of lead acid and nicad battery:

  • the cell in nicad battery can be replaced

A buck-booster converter with a 30kHz switching frequency is operating with D=0.25. the connected load is 10O. Determine the crirtical frequency so that current IL is continous.

  • Lc = (1-D)2 RL

        2Fs

Unity follower amplifier is an ________ input impedance, leading to its use as an intermediate stage (buffer) amplifier to prevent small load impedance from loading a source:

  • Extremely High

Typical value of CMMR:

  • ranging from 100 to 10,000

Typical value of CMMR in dB:

  • ranging from 40dB to 80Db

Of the wire is the maximum current, it can safely carry.

  • Ampacity

 ____can keep the display for a longer time for analysis purposes.

  • Storage oscilloscope

With permeability tuning, moving the core further into solenoid coil,

  • increase the inductance

The best type of core if you need a winding inductance of 1-2 henrys:

  • ferromagnetic pot core

For advanced chip, the distance between component is.

  • 1 µm

Electrostatic meter:

  • can detect ac voltages

What is an electronic oscillator?

  • an amplifier with feedback

The current in the solar panel can be increased by:

  • connecting solar panel in parallel

A diode that is designed to operate reversed voltage and is manufactured to a process that increases voltage dependent depletion capacitance or junction capacitance:

  • varactor  diode

In transistor consideration, _________ analysis is based on the assumption that for small changes, the variable interest is a linear function of the other variable and thus the differential can be replaced by its increment.

  • stability factor or sensitivity

No comments:

Post a Comment